Abbracciame Candle for tealight

Abbracciame Candle 3D printed lamp designed by David Bitton and Adriano Alfaro – white version made of PLA compostable plastic + one tealight LED candle.

140

Specifications

  • Height – 20 cm
  • Diameter – 8,5 cm
  • Material – PLA

Frequently Asked Questions

Color

Abbracciame Candle is only available in white.

3D printing material

Abbracciame vases are 3D printed in polylactic acid (PLA), which is a thermoplastic aliphatic polyester derived from renewable biomass, typically from fermented plant starch such as from corn, cassava, sugarcane or sugar beet pulp. It is an eco-friendly and compostable material – we care about our planet!

Please note that, because of the 3D printing technology, the surface of the vase may have some imperfections, as well as visible layer lines up to 0,2 mm thick.

Maintenance

To extend the Abbracciame Candle lifespan, please follow these directions:

  • Do not put the vase near heat sources or real tealight candles, as the material will start to sag at 60° C.
  • Avoid putting Abbracciame in the Sun, especially the black, blue and other dark editions.
  • Clean the vase with a wet paper-towel and delicate soap or alcohol.
  • Do not directly fill the vase with water or any other liquid.
Lighting (included)

Abbracciame Candle is sold with one tealight LED candle. This fake candle can last up to 24 hours, depending on the quality of the battery you use. The LED light is warm and flickers like a real candle.

Do not use real tealight candles!

Shipping

Abbracciame vases are shipped from Italy, where are produced. 3D printing and shipping may take up to two weeks.